Email Adddress: [email protected]

fly ash as replacement of sand

fly ash as replacement of sand

A study of fine aggregate replacement with fly ash an ...

The use of fly ash as a replacement of sand has a great potential to benefit our society in terms of reducing demand of natural sand, reducing environmental problems, conserving energy and reducing landfill area requirement. This paper presents an approach to increase the utilization of fly ash and

Get Price

Parametric Study for Replacement of Sand by Fly Ash

The use of fly ash as replacement of sand is an economical solution for making green and denser concrete. The paper presents a concrete mix design procedure for partial replacement of sand with fly ash. Present method could produce additional compressive and flexural strength for concrete with partial replacement of sand with fly ash over control ...

Get Price

Parametric Study for Replacement of Sand by Fly Ash for ...

2015-3-12  replacement of 15% sand with fly ash by weight increased the compressive strength by about 30%. They also reported good surface finish due to addition of fly ash as replacement of sand which also reduces the permeabil-ity and has an attractive dark colour.

Get Price

Feasibility Study of Fly Ash as a Replacement for Fine ...

2016-9-9  The main objective of this experimental study is to investigate the strength performance of concrete produced by replacing natural sand by fly ash in various percentages like 0%, 10%, 20%, 30%, 40%, 50%, 60%, 70% and 80% when subjected to sustained elevated temperature of 200°C, 400°C, 600°C and 800°C. The various strength parameters studied are compressive strength, tensile

Get Price

Old Dumped Fly Ash as a Sand Replacement in

The use of industrial residues to replace natural resources for the production of building materials is economically and ecologically justified. Fly ash (FA) taken directly from electro-filters is commonly used as a cement replacement material. This is not the case, however, for old dumped fly ash (ODFA) that has been accumulating in on-site waste dumps for decades and currently has no ...

Get Price

Study on Partial Replacement of Sand with Fly Ash in ...

2020-9-1  The utilization of fly ash as sand partial replacement in concrete mix is an alternative solution for the depletion of sand resources in the Special Region of Yogyakarta. This research evaluates the effect of sand partial replacement with fly ash to the strength-weight and cost-strength ratio of

Get Price

Effect of coal bottom ash as partial replacement of

Bottom ash forms up to 25% of the total ash while the fly ash forms the remaining 75%. One of the most common uses for bottom ash is as structural fill. Published literature shown that there is a strongly possibility of coal bottom ash being used as substitute/replacement of fine aggregate (sand).

Get Price

EFFECT OF FLY ASH AND QUARRY DUST AS A PARTIAL

2018-11-5  a waste product is becoming problem for its disposal. Due to the scarcity of natural sand is overcome by utilization of quarry dust, which can be called as manufactured sand. Hence an attempt has been made to study the effect of partial replacement of fine aggregates by quarry dust and cement by fly ash on cement concrete.

Get Price

Reuse of fly ash and bottom ash in mortars with

2018-11-1  Rafieizonooz et al. (2016, 2017) had tried to explore the effect of bottom ash and fly ash in concrete, as replacement of sand and cement respectively. Sand was replaced at 20, 50, 75 and 100% rate and cement was replaced at flat 20% rate for all four proportions of sand replacement.

Get Price

Use of Unprocessed Wood Ash as Partial Replacement

The use of unprocessed low-calcium wood ash as partial substitution of natural sand in manufacturing of concrete has been explored in the present study. X-ray diffraction (XRD) spectrum indicates the presence of amorphous as well as crystalline silica in unprocessed wood ash.

Get Price

A study of fine aggregate replacement with fly ash an ...

Replacement of 50% sand with fly ash can save about 0.4 m3 sand. Comparison of cost per N/mm2 compressive strength has shown about 40% to 60% saving in cost. Based on the experimental results, correlations are developed for finding out the compressive strength and cost at 28 and 91 days. Sand was replaced with 10% to 50% of fly ash by weight ...

Get Price

Old Dumped Fly Ash as a Sand Replacement in

The use of industrial residues to replace natural resources for the production of building materials is economically and ecologically justified. Fly ash (FA) taken directly from electro-filters is commonly used as a cement replacement material. This is not the case, however, for old dumped fly ash (ODFA) that has been accumulating in on-site waste dumps for decades and currently has no ...

Get Price

Study on Partial Replacement of Sand with Fly Ash in ...

The utilization of fly ash as sand partial replacement in concrete mix is an alternative solution for the depletion of sand resources in the Special Region of Yogyakarta. This research evaluates the effect of sand partial replacement with fly ash to the strength-weight and cost-strength ratio of concrete mixes. The strength-weight ratio was used for mechanical evaluation with higher value ...

Get Price

Utilization of fly ash as partial sand replacement in oil ...

The effect of fly ash content as partial sand replacement towards workability and compressive strength of OPS lightweight aggregate concrete were investigated. Four concrete mixes containing various percentage of fly ash that are 0%, 10%, 20% and 30% by weight of sand

Get Price

Influence of Fly Ash Content and Desert Sand

Under the same amount of fly ash content, desert sand replacement ratio was 0%, 20%, 30%, 40%, 60%, 80% and 100%, respectively. Concrete specimen was cast in moulds with the dimension of 150×150×300 mm. All specimens were demoulded after 24h, then cured in

Get Price

A Mix Design Procedure for Replacement of Sand with

2011-1-1  Abstract. The use of fly ash as a replacement of sand is an economical solution for making green and denser concrete. The paper presents a concrete mix design procedure for partial replacement of sand with fly ash, which could produce a compressive strength of 46 N/mm2 with 10 mm higher slump with concrete mix design for M30 concrete because of better particle packing by the inclusion of fly ...

Get Price

Replacement in a Non-Load Bearing Fly ASH Bricks Study

2020-12-15  Study on The Mechanical Properties of Bottom ASH as a Partial Sand Replacement in a Non-Load Bearing Fly ASH Bricks Article May 2019 DOI: 10.21276/sjce.2019.3.3.2 CITATIONS 0 READS 24 3 authors , including: Some o f the authors of this

Get Price

Utilization of MSWI fly ash as partial cement or sand ...

2019-4-23  The macropores assigned to the gaps between particles decreased when the fly ash was used as sand replacement, providing an explanation for the strength enhancement. The waste-extraction procedure (toxicity-sulphuric acid and nitric acid method (HJ/T 299-2007)) was used to evaluate metal leaching, indicating the reuse possibility of fly ash blended mortar.

Get Price

Wood ash used as partly sand and/or cement

Catalogue and hazardous residues list [1], both bottom ash and fly ash from combustion of untreated wood are classified as non-hazardous wastes. This paper is focused on the use of WA in concrete. Use as cement replacement offers environmental gains from lowering CO 2

Get Price

Use of Unprocessed Wood Ash as Partial Replacement

Use of Unprocessed Wood Ash as Partial Replacement of Sand in Concrete. The use of unprocessed low-calcium wood ash as partial substitution of natural sand in manufacturing of concrete has been explored in the present study. X-ray diffraction (XRD) spectrum indicates the presence of amorphous as well as crystalline silica in unprocessed wood ...

Get Price

Old Dumped Fly Ash as a Sand Replacement in

The use of industrial residues to replace natural resources for the production of building materials is economically and ecologically justified. Fly ash (FA) taken directly from electro-filters is commonly used as a cement replacement material. This is not the case, however, for old dumped fly ash (ODFA) that has been accumulating in on-site waste dumps for decades and currently has no ...

Get Price

Study on Partial Replacement of Sand with Fly Ash in ...

The utilization of fly ash as sand partial replacement in concrete mix is an alternative solution for the depletion of sand resources in the Special Region of Yogyakarta. This research evaluates the effect of sand partial replacement with fly ash to the strength-weight and cost-strength ratio of concrete mixes. The strength-weight ratio was used for mechanical evaluation with higher value ...

Get Price

Utilization of fly ash as partial sand replacement in oil ...

The effect of fly ash content as partial sand replacement towards workability and compressive strength of OPS lightweight aggregate concrete were investigated. Four concrete mixes containing various percentage of fly ash that are 0%, 10%, 20% and 30% by weight of sand

Get Price

A study of fine aggregate replacement with fly ash an ...

2010-10-1  Sand was replaced with 10% to 50% of fly ash by weight and 0.5, 0.55, 0.6 and 0.65 W/C ratios were used. Flow test performed for mortar revealed that as the percentage replacement of sand with the fly ash increased the flow of the mortar decreased.

Get Price

Class C Fly Ash as a Full or Partial Replacement for ...

density. The fly ash percentage corresponding to the maxi­ mum density of the A-2-4 silty sand also seemed to coincide with the minimum value of the optimum moisture content. Other mix combinations of cement plus fly ash and lime plus fly ash with the A-3 sand also produced gains in density.

Get Price

Replacement in a Non-Load Bearing Fly ASH Bricks Study

2020-12-15  Study on The Mechanical Properties of Bottom ASH as a Partial Sand Replacement in a Non-Load Bearing Fly ASH Bricks Article May 2019 DOI: 10.21276/sjce.2019.3.3.2 CITATIONS 0 READS 24 3 authors , including: Some o f the authors of this

Get Price

Synthesis and Characterization of Fly Ash Geopolymer

Geopolymerization of fly ash amorphous silica mixtures is employed to produce fine aggregates as a possible replacement to river sand. Geopolymerization of fly ash amorphous silica mixtures in 10 M NaOH solution at 100°C for 7 days produced fine aggregates [termed fly ash geopolymer sand (FAPS)] that had comparable grain size distribution ...

Get Price

Use of Unprocessed Wood Ash as Partial Replacement

Use of Unprocessed Wood Ash as Partial Replacement of Sand in Concrete. The use of unprocessed low-calcium wood ash as partial substitution of natural sand in manufacturing of concrete has been explored in the present study. X-ray diffraction (XRD) spectrum indicates the presence of amorphous as well as crystalline silica in unprocessed wood ash.

Get Price

Synthesis and characterization of synthetic sand by ...

2021-5-29  Agrawal US, Wanjari SP, Naresh DN (2017) Characteristic study of geopolymer fly ash sand as a replacement to natural river sand. Constr Build Mater 150:681–688. CAS Article Google Scholar Ahmaruzzaman M (2010) A review on the utilization of fly ash. Prog Energy Combust Sci 36(3):327–363

Get Price

UTILIZATION OF POND ASH AS PARTIAL REPLACEMENT

2016-4-23  Aparna K.A et. al (2015) performed partial replacement of cement and sand using fly ash and pond ash. The grade of concrete is M40, cube and beam specimens are casted and cured for 28 and 56 days. The 20%FA, 18%PA mix will give a high flexural strength of 11.16 N/mm2 for a curing period of

Get Price

A Mix Design Procedure for Replacement of Sand with

2011-1-1  Abstract. The use of fly ash as a replacement of sand is an economical solution for making green and denser concrete. The paper presents a concrete mix design procedure for partial replacement of sand with fly ash, which could produce a compressive strength of 46 N/mm2 with 10 mm higher slump with concrete mix design for M30 concrete because of better particle packing by the inclusion of fly ...

Get Price

Study on Partial Replacement of Sand with Fly Ash in ...

The utilization of fly ash as sand partial replacement in concrete mix is an alternative solution for the depletion of sand resources in the Special Region of Yogyakarta. This research evaluates the effect of sand partial replacement with fly ash to the strength-weight and cost-strength ratio of concrete mixes. The strength-weight ratio was used for mechanical evaluation with higher value ...

Get Price

A study of fine aggregate replacement with fly ash an ...

The use of fly ash as a replacement of sand has a great potential to benefit our society in terms of reducing demand of natural sand, reducing environmental problems, conserving energy and reducing landfill area requirement. This paper presents an approach to increase the utilization of fly ash and conserve scarcely available natural sand for sustainable development.

Get Price

Class C Fly Ash as a Full or Partial Replacement for ...

density. The fly ash percentage corresponding to the maxi­ mum density of the A-2-4 silty sand also seemed to coincide with the minimum value of the optimum moisture content. Other mix combinations of cement plus fly ash and lime plus fly ash with the A-3 sand also produced gains in density.

Get Price

Wood ash used as partly sand and/or cement

Catalogue and hazardous residues list [1], both bottom ash and fly ash from combustion of untreated wood are classified as non-hazardous wastes. This paper is focused on the use of WA in concrete. Use as cement replacement offers environmental gains from lowering CO 2

Get Price

Synthesis and Characterization of Fly Ash Geopolymer

Geopolymerization of fly ash amorphous silica mixtures is employed to produce fine aggregates as a possible replacement to river sand. Geopolymerization of fly ash amorphous silica mixtures in 10 M NaOH solution at 100°C for 7 days produced fine aggregates [termed fly ash geopolymer sand (FAPS)] that had comparable grain size distribution ...

Get Price

Effect of coal bottom ash as a partial replacement of

Bottom ash is mainly comprised of fused coarser ash particles. These particles are quite porous and look like volcanic lava. Bottom ash forms up to 25% of the total ash while the fly ash forms the remaining 75%. One of the most common uses for bottom ash is as structural fill.

Get Price

Effect of class F fly ash on fine sand compaction through ...

2019-9-27  Fly ash has a broad range of applications within the construction industry (Fig. 3). The utilization of FA as a partial replacement for Portland cement in concrete is widespread and considerable volumes are used. Looking at the US FA utilization in that figure, nearly, 60% of the total FA produced was unutilized in 2014 (which,

Get Price

UTILIZATION OF POND ASH AS PARTIAL REPLACEMENT

2016-4-23  Aparna K.A et. al (2015) performed partial replacement of cement and sand using fly ash and pond ash. The grade of concrete is M40, cube and beam specimens are casted and cured for 28 and 56 days. The 20%FA, 18%PA mix will give a high flexural strength of 11.16 N/mm2 for a curing period of

Get Price

Study Of Various Fineness Of Fly Ash As A Partial ...

2016-9-9  25%, and 37.5% replacement of various fineness Fly ash to study the mechanical properties such as compressive strength at different ages of concrete such as 7, 28, and 90 days. The mix Design as per IS 10262-1982. Keywords: Fly ash, partial replacement, cement ,fine and coarse aggregate, water ,compressive strength. Introduction

Get Price